&The bracket is made of plastic steel, which is not only pressure-resistant but also anti-aging.
&The tray and feet are made of plastic, which is tough, wear-resistant and durable
Use Scope:
& Suitable for placing fully automatic pulsator & drum washing machine & ordinary refrigerator
Material:
&&Special engineering modified plastic, waterproof and UV resistant
& Plastic steel,
&&Fixing screws
Bearing capacity:
Size:
&Maximum adjustable C
&Minimum adjustable C
Features:
&Easy to move & easy to clean &The bracket legs can be locked and fixed, making horizontal adjustment more convenient
Advantages:
&&It prevents the machine from directly contacting the ground and damaging the floor, and protects the machine from shortening its life due to moisture on the floor or moisture at the bottom during drainage.
&If your balcony or bathroom often accumulates water, it is even more necessary to increase the height of your washing machine. The distance between the rack and the ground is centimeters
&&The size can be adjusted to suit various needs. A washing machine and refrigerator of various styles and sizes, with an elegant design and strong practicality
&&Beautiful appearance, durability and affordability. Although the wooden or welded iron frames made by others are cheap, they are unsightly and not durable.
& After a short time of use, they will be corroded by moisture or rusty, and you will have to spend a lot of money to make them again.
Installation method:
& First, measure the length and width of the machine, and then connect the corner pieces (with rods). Note that the four tubes on the corner pieces are not the same length, but two lengths. Two short tubes should be assembled symmetrically
(that is, the long tube is used in the longer part of the machine, and the short tube is used in the shorter part of the machine). After determining the length and width of the adjustment frame, be sure to lock the length and width with fixing screws. Then install the four adjustment feet and adjust them to the lowest position. Place the machine on it, move it to the designated position, level the feet according to the height of the ground, and finally tighten the positioning spiral ring, and you're done. .